CAB A6 Instrukcja Operatora Pobierz pdf (Strona 106)

A-2 cab Produkttechnik GmbH & Co KG

A3-2 / A3 / A4 / A6

Prelimininary Tests

The media width and height given in the Technical Specifications are suggested

values for media when using the present sensor :

Label Width : A3-2: 1 to 2.3 in (25-60 mm)

A3, A4: 1 to 4.6 in (25-116 mm)

A6: 2 to 6.9 in (50-176 mm)

Label Height : A3-2, A3, A4: .5 to 7.9 in (12-200 mm)

A6: 1 to 7.9 in (25-200 mm)

CAUTION !

When using different media from the specifications, for example

- media which is smaller than the specifications above,

- very thin media,

- very thick silicon liner,

- media with aggressive adhesive,

- transparent media

it is recommended to test the media before !

For A3 the print speed in the peel-off mode is limited to maximum 4 ips

(100mm/s). This limitation guarantees a correct operation in the dispense

mode when using maximum supply rolls (diameter 8 in (203mm), width 4.7 in

(120mm)) also with A3. When using supply rolls with a small outside diameter it

is possible to increase the print speed during on-demand labelling. For that

purpose the speed limitation has to switch off. Then the print speed can be set

on all possibilities until 8 ips (200mm/s) for A3/200P or until 6 ips (150mm/s) for

A3/300P.

CAUTION !

When operating the A3 with higher speed it is strongly recommended to

carry out preliminary tests using the appropriate maximum rolls !

For A3-2, A4 and A6 there is no limitation of the print speed in peel-off mode.

Present Sensor, Peel-off Adapter, Tamp Applicator

Detailed information about the different peel-off modules can be found in the

concerning Operator's Manuals.

Appendix A - Operation in Peel-off Mode

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 137 138

Brak uwag

CAB A6 Instrukcja Operatora Strona 106