CAB Apollo 1 Instrukcja Operatora Pobierz pdf (Strona 82)

82 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.

Code Printout Code Printout Code Printout Code Printout

DEC HEX DEC HEX DEC HEX DEC HEX

00 00 08 08 16 10 24 18

01 01 09 09 17 11 25 19

02 02 10 0A 18 12 26 1A

03 03 11 0B 19 13 27 1B

04 04 12 0C 20 14 28 1C

05 05 13 0D 21 15 29 1D

06 06 14 0E 22 16 30 1E

07 07 15 0F 23 17 31 1F

Table 12 Representation of the control characters in monitor mode

12 Monitor Mode/ ASCII Dump Mode

If programming directly, the monitor mode provides a method to print control

sequences which were received at the interface. The commands will be

printed in text format depending on the selected character set. Error messages

will be printed directly behind the fault, e.g. for unknown commands.

In monitor mode, the Apollo will not recognize gaps between labels nor control

the ribbon feed.

NOTICE !

The font used for printouts in monitor mode is suitable to send by

facsimile. For questions or future reference, print and retain one copy of

the label format for each label printed.

Start of Monitor Mode/ ASCII Dump Mode

To start the monitor mode, press the key while switching on the printer,

and keep it pressed down until the system test is completed. The display

shows "ASCII Dump Mode".

To cancel ASCII Dump mode, press the key.

In monitor mode, the print of data will be started after every four lines of data

received. Therefore, in some cases, the last lines of the label have to be

retrieved by pressing the key.

Representation of the Control Characters

The control characters (ASCII Code 00 ... 31) as shown in monitor mode

printouts are as follows.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 138 139

Brak uwag

CAB Apollo 1 Instrukcja Operatora Strona 82